1-1. Outline
The BKP-590 is a circuit board kit that enables Betacam
CCD color video cameras such as the BVP-90 and others
(excluding BVP-5/50) to be connected directly to the
CCU-700 series via the CA-57A/57AP.
Wide band transmission
The video bandwidth is extend to 10 MHz by increasing
the transmission bandwidth of the triax system.
NCS (New Command System) is supported
Owing the BKP-590, a conventional camera can be
connected to the new command system (used in the CCU-
700 series) which is employed in the Sony camera.
1-2. Installation
n
Before installing the BKP-590 to the CA-57A/57AP,
remove the triax cable from CCU connector so that the
BKP-590 is installed to the CA-57A/57AP with the triax
cable removed.
Contents of BKP-590
MD-111 board
TR-92 board
IF-562 board
MPX filter
Cushion
Hexagon support
Discernment label
CCU label
Lithium battery
*1)
*1): As necessary, remove the two solder on the IF-562 board, replace the
lithium battery (BT1).
Lithium battery
+ lead
– lead
BKP-590
Section 1
Installation
: 1
: 1
: 1
: 1
: 2
: 2
: 1
: 1
: 1
IF-562 board
1. Loosen the four screws and remove the side panels
(left and right).
Side panel (left)
Screws
2. Remove the MD-74, TR-60 and IF-424 boards.
3. Remove the one screw and remove the shielding plate.
MD-74 board
CA-57A/57AP
Side panel (right)
Screws
Screw
IF-424 board
Shielding plate
TR-60 board
1-1(E)