Table of Contents
Advertisement
OPERATION
CAUTION! Ensure that the mains voltage is correct!
The voltage of the power source must agree with the value given on the
nameplate of the machine. Machines designated for 230V can also be
operated with 220 V.
To switch on the machine, press the ON/OFF switch (8)Lock the
depressed ON/OFF switch (9) by pressing the lock-on button (10).
To switch off the machine, release the ON/OFF switch (9) or push and
then release it.
Operating Modes
The operation of the gearbox for each application is set with the mode
selection switch (7):
HAMMERING MODE (Fig. 9)
Turn the mode selection switch (7) to the "
DRILLING MODE (Fig. 10-12)
Turn the mode selection switch (7) to the "
The operating mode selection switch may be actuated only at a
standstill.
WARNING! Do not use tools without SDS-plus for hammer drilling
or chiseling!
The following table shows how the mode selection switch (7), and the
right/left rotation switch (8) as well as the ON/OFF switch (9) for
regulation the speed are to be set for the various operating modes:
Hammer drilling in concrete or stone (Fig. 9)
Drilling in steel or wood (Fig. 10)
Screw driving:
Right rotation (Fig. 11)
Left rotation (Fig. 12)
MAINTENANCE
1. For safe and proper working, always keep the machine and
ventilation slots clean.
2. A damaged dust protection cap should be changed immediately.
We recommend having this carried out by an after-sales service.
3. Approximately every 10 hours of operation, please check the
grease reservoir as follow steps:
a) Lift the tap of oil seal cap (9), loosen the cap counter clockwise
with fingers to open the grease reservoir.
b) Remove the corresponding amount of grease from container
and press it into the reservoir.
c) Replace the oil seal cap to the grease reservoir and secure it
by turning clockwise.
4. Worn carbon brushes are to be replaced only by a specialist
workshop. It is recommended that you take this tool to a Ryobi
Authorized Service Center for a through cleaning and lubrication
at least once a year.
It is recommended that you take this tool to a Ryobi Authorized
Service Center for a through cleaning and lubrication at least once
a year.
DO NOT MAKE ANY ADJUSTMENTS WHILE THE MOTOR IS IN
MOTION.
ALWAYS DISCONNECT THE POWER CORD FROM THE
RECEPTACLE BEFORE CHANGING REMOVABLE OR
EXPENDABLE PARTS (BLADE, BIT, SANDING PAPER ETC.),
LUBRICATING OR WORKING ON THE UNT.
CAUTION!
USE ONLY THE GREASE APPROVED BY RYOBI FOR THE
PRODUCT. OTHER GREASE CAN BE DAMAGE YOUR PRODUCT.
" direction.
" direction.
- 6 -
WARNING!
To ensure safety and reliability, all repairs should be performed
by an AUTHORIZED SERVICE CENTER or other QUALIFIED
SERVICE ORGANIZATION.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Advertisement
Table of Contents
