Troubleshooting - Eberg VISIV User Manual

Troubleshooting

Normal failure phenomenon Check/Solution
1. Whether the power plug is inserted well?
Can't switch on - Insert the power plug well.
(Power lamp not lighted) Whether the left and right air inlet panel of purifier is covered well?
- Cover left and right air inlet panel of purifier.
Can't switch on Whether the roof air outlet grid network is installed To ensure the
(Power lamp twinkle), air outlet grid network be straight.
button no response - Install the roof air outlet grid network in place
There's pollution in air while Whether the purifier is put in a place where it's easy to bring the
the indication lamp still polluted air.
not turn „blue". - Change the position of purifier.
Even running consequently,
Whether the particle sensor is dirty?
the air pollution indication
- Clean the particle sensor.
lamp is kept „red".
„Papa" , " Lang" sound exist Whether there's too many dust in anion generator?
during running. - Clean the anion generator.
Whether the filter screen is dirty?
The smell of the outlet makes - Clean the filter screen i Whether the filter screen is not replaced
people uncomfortable. for long time?
- Replace the filter screen regularly.
The purifier not enter the Whether the purifier is running under manual mode?
sleep mode automatically in - Press the „Automatic" button on operation panel to ensure purifier
night. running under automatic mode.
32
Troubleshooting
GB
4. Smart replacement reminder for filter screen
- Turn off the power and remove the plug from socket
- Open the rear cover and take off the primary effect filter screen in the same way as „Cleaning of
primary effect filter screen".
- According to the panel replacement indication, take out the HEPA composite filter screen from the
machine frame and put a new filter screen into filter screen frame in sequence, then install the filter
components back on the purifier.
- Smart replacement reminder for filter screen
- Finally, switch off the power and install the rear cover on product frame.
Wipe the sensor lens lightly with cotton
swab after taking off the anti-dust cover.
HEPA high-efficiency Primary effect
composite filter filter screen
filter screen key
Clean the air sensor door cover
by vacuum cleaner or hair dryer.
GB
Front cover
33