Bkds-7017 - Sony BKDS-7017 Installation Manual

5-1-3. BKDS-7017

1. CPU-246 Board
CN9
CN8 CN17
COP1
COP3
CN15
CN14
COP2
CN16
CN18 CN21
S5
(Component side/A side)
COP1 (E3) :
This is used to select the mode corresponding to the synchronized signal that is connected to the
SWITCHER on the rear panel. For DVS-7150, this is opened under normal status.
COP3 (E3) :
This is used to select the RS-232C signal that is connected to the TERMINAL 2 on the rear panel.
Selection under normal status ; NOR side
Selection in the factory
S1 (R10) : RESET switch
This switch is used to forcibly restart the SYSTEM by the hardware. The unit is operated the same as the
operation when turning the POWER ON.
S2 (R19) : ABORT switch
This switch is used for the adjustment in the factory.
S3 (R10) : SUB ABORT switch
This switch is used for the adjustment in the factory. If pressing this switch after selecting the S5 switch
on the CPU-246 board to the SUB CPU flash memory access protection mode, clean the content of the
flash memory for stored-program.
DVS-7150E IM
CN10 CN1
IC39
CN13
CN12
D112 D102
CN20
S4
CPU-246 board
; DBG side
CN5 CN3
CN6 CN4
D27
D26
D25
D24
D23
D22
D18
D17
D16
D6
D7
Factory setting
D2
D1
S4, S5
D295
D8
S3 ON
S2
S1
CN19
1 2
5-1. Switch Settings on Boards and LEDs Description
3 4 5 6 7 8
5-7