BRP EVINRUDE ICON Series Instructions Manual page 8

ICON Concealed Side Mount Remote Control Connections
Connect remote control buss cable to ICON hub. If the installation requires a buss cable extension,
use no more than one extension. Connect P-1 and P-2 Deutsch connectors from harness to Control
Module. Push connectors together until latched. Connect P-3 Deutsch connector from harness to P-4
Deutsch connector of remote control. Push connectors together until latched. Apply a light coat of
Electrical Grease onto the seal of the Deutsch connector for the trim and tilt switch. Push connectors
together until latched.
4
3
1. Buss cable, remote control to ICON hub
2. Deutsch connector, P-1 from harness to control module
3. Deutsch connector, P-2 from harness to control module
4. Control module
5. Deutsch connector, P-3 from harness to remote control
6. Deutsch connector, P-4 from remote control to harness
Check operation and movement of control lever. Make sure remote control shift and throttle functions
operate smoothly. Refer to REMOTE CONTROL OPERATION TESTS on page 9.
8 of 14
9
3
P-2
P-1
2
4
3
10
1
2
7. Seal, Deutsch connector
8. Deutsch connector, trim and tilt
9. Buss cable, master power/key switch to ICON hub
10. Network power cable to battery
RPM NEUTRAL
M
B
A
M
1
5
P-3
8
P-4
6
START/
STOP
A B C
7
A B C
007974