Installation Procedure; Mounting Holes - BRP EVINRUDE ICON Series Instructions Manual

INSTALLATION PROCEDURE

Refer to the ICON System Quick Connection
Guide, P/N 765409 for ICON System Diagram.
Disconnect the battery cables at the battery.
Test remote control operation after installation is
complete.
WARNING
Failure to properly install and test remote
control operation may result in remote
control malfunction and the loss of boat
control.
Mounting Location
Select an appropriate location based on the boat
configuration.
1
1. Side console
IMPORTANT: The mounting location must be a
flat surface and must be strong enough to pro-
vide a rigid support. Strengthen mounting sur-
face as necessary. Remote control cannot be
installed if thickness of mounting surface ex-
ceeds 1.2 in. (30 mm).
Refer to ICON CONCEALED SIDE MOUNT
REMOTE CONTROL PROFILE DRAWING on
page 11.
Place remote control at proposed location and
check clearance around remote control handle at
full throttle in FORWARD and then at full throttle
in REVERSE. There must be at least 4 in. (102
mm) of clearance between the handle and any
4 of 14
part of the boat throughout the control handle
travel.
85.5°
4 in (102 mm)
There must be sufficient clear space behind the
control for the housing and cable routing.

Mounting Holes

Refer to ICON CONCEALED SIDE MOUNT
REMOTE CONTROL - DRILL TEMPLATE on
page 13.
IMPORTANT: Make sure the mounting location
has all the required clearances before drilling or
cutting.
Position template. Use center punch and mark
the centers of drill locations.
006152A
1
1. Template
Cut along the outer line of shaded area. Use
appropriate cutting tools. A 2 7/8 in.(73mm) hole
saw can be used for main through hole.
NEUTRAL
FWD REV
15° 15°
40.5°
007973
006338