Maintenance - BRP EVINRUDE ICON Series Instructions Manual

On Water Test
Secure boat to dock to prevent motion. Snap the
emergency stop lanyard to a secure place on the
operators clothing or life vest – not where it might
tear away instead of activating the stop switch.
Push clip of emergency stop lanyard onto master
power switch.
1
RUN
OFF
2
1. Clip
2. Master power switch
WARNING
Lanyard MUST be securely attached to
operator, and clip MUST be installed on
master power switch. DO NOT operate
outboard with clip removed from switch,
except in an emergency.
Refer to the ICON User's Guide for remote
control operation.
Position control lever in the NEUTRAL position
to start or stop outboard.
Turn master power/key switch to RUN position.
Press START symbol of START/STOP switch.
Release switch as soon as outboard starts.
Check shift operation. Check that outboard shifts
into FORWARD gear when control is shifted to
FORWARD, and shifts to REVERSE gear when
control is shifted to REVERSE.
10 of 14

MAINTENANCE

CAUTION
Inspection and maintenance must be per-
formed with outboard stopped. Discon-
nect emergency
disconnect the battery cables at the bat-
tery to prevent accidental starting of out-
board.
Check mounting of remote control. Tighten
locknuts or secure as needed.
If an abnormal condition is found, repair as
needed. Replace all damaged parts.
Check operation and movement of control
levers. Make sure remote control shift and
throttle functions operate smoothly. Refer to
REMOTE CONTROL OPERATION TESTS on
005499A
page 9.
Keep remote control clean using a cloth
dampened in fresh water.
stop lanyard and