Operational Tests - BRP EVINRUDE ICON Series Instructions Manual

Connect power cable connector to harness
connector. Make sure connector latches.
1
3
1. Purple wire from harness
2. Accessory power wire
3. Power cable connector
Connect the ring terminal from the power cable
to a positive (+) 12 volt source.
Use additional tie straps to secure harnesses
and cables once installation of all components is
complete.
Connect the battery cables at the battery.
4 of 5

OPERATIONAL TESTS

Turn the master power/key switch to the RUN
position. All devices connected to the ICON
control system, the gauge network and the
accessory power relay kit should turn on.
2
Check operation of accessory items connected
to the accessory power relay kit.
Turn the master power/key switch to the OFF
position.
007911