BRP EVINRUDE ICON Series Instructions Manual page 3

Install terminal block with two #10 screws (obtain
locally). Tighten screws securely.
1
1. Terminal block
Identify power cable routing. Install power cable
in boat.
1. Power cable
ICON Network Buss Cables
ICON network buss cables use a proprietary
6-pin threaded, Molex-type connector.
1. ICON buss cable connectors
IMPORTANT: Do not force connectors or lock-
ing rings. Properly aligned connectors assemble
easily.
Do not use Electrical Grease on ICON buss
cable connectors.
To assemble the connectors:
• Use the large tabs and small tabs to carefully
align buss cable connectors.
• Carefully align pins and sockets of connec-
tors. Do NOT force connectors together.
• Tighten locking rings of buss connectors fin-
ger tight. Do NOT use locking rings to force
connectors together.
007909
1
1. Large tabs
2. Small tabs
Do not rotate connectors until they align. This
could result in a mismatched connection. It is
possible for each pin to enter a socket even if the
tabs are misaligned. Look at the tabs to ensure
connector alignment prior to making the
connection.
007910
ICON Accessory Power Relay
Connection
Connect accessory power relay buss cable to
ICON network hub.
If the installation requires a buss cable
extension, use no more than one extension.
Optional lengths are available.
Accessory Power Relay Electrical
Connections
Attach purple wire from the harness to the
terminal block.
Connect positive (+) wire(s) from accessory to
the terminal block.
007882
1
2
007883
3 of 5