BRP EVINRUDE ICON Series Instructions Manual page 3

Install gateway module and secure with two #10
screws. Tighten screws securely.
1. #10 screws
ICON Network Buss Cables
ICON network buss cables use a proprietary
6-pin threaded, Molex-type connector.
1. ICON buss cable connectors
IMPORTANT: Do not force connectors or lock-
ing rings. Properly aligned connectors assemble
easily.
Do not use Electrical Grease on ICON buss
cable connectors.
To assemble the connectors:
• Use the large tabs and small tabs to carefully
align buss cable connectors.
• Carefully align pins and sockets of connec-
tors. Do NOT force connectors together.
• Tighten locking rings of buss connectors fin-
ger tight. Do NOT use locking rings to force
connectors together.
1
1. Large tabs
007915
2. Small tabs
Do not rotate connectors until they align. This
could result in a mismatched connection. It is
possible for each pin to enter a socket even if the
tabs are misaligned. Look at the tabs to ensure
connector alignment prior to making the
connection.
ICON Gateway Module Connection
Connect gateway module buss cable to ICON
network hub.
If the installation requires a buss cable
extension, use no more than one extension.
Optional lengths are available.
007882
ICON Gateway Module Power
Connection
Apply a light coat of Electrical Grease™ onto the
Deutsch connector seal.
Connect the electrical connector from the master
power/key
connector of the gateway module. Make sure
connector latches.
1
2
switch harness to
007883
the power
3 of 5