Antifreeze Function; Troubleshooting; Maintenance; Disposing Of The Device - TERMA MEG 1.0 User Manual

ANTIFREEZE FUNCTION

If the heater is off and the temperature will fall below 5-7 C, the timer automatically turn on the heater
for as long as temperature is below this level. During this time central LED blinks.
VII. TROUBLESHOOTING
1. Both side leds alternate blinking indicate alarm mode.
2. Failure can be caused by following:
a) temperature sensor damage,
b) heating element damage,
c) overheating
3. To restore the heater to operating mode make following steps:
1. Check if a radiator is filled-up with heating liquid properly
2. If not – refill heating liquid; Attention! Disconnect supply of electricity
3. Switch off the heater using button [5]. The device must be plugged in.
4. Wait about 30 min. till the radiator's temperature falls down, watching if the heater is not working
5. If the heater was working despite it was switched off using button [5] that means permanent damage.
Screw out the heater and sent to service.
6. If the heater was not working. Switch it on using button [5].
7. If the heater presents alarm mode again that means permanent damage. Screw out the heater
and sent to service.
4. Apart form situations described above in case of any abnormal operating signs are noticed, plug the heater
off and contact service.
VIII. MAINTENANCE
1. You must not use any liquid that contains solvents as well as abrasive materials to clean the device.
2. While cleaning with any liquid plug the heater off and do not pour the device.
IX. DISASSEMBLY
1. Switch off the heater using button [5].
2. Plug off the device.
3. If the heater is installed in a radiator connected to heating system close both valves on supply and return.
In case of electrical radiator disassembly all set.
4. Pour out heating liquid. In case of electrical radiator turn the radiator up side down
(pouring out the liquid is not necessary)
5. Screw out the heater using 22 spanner, catching a head (cap) [3].
ATTENTION ! Using other tools or turning by casing [2] can damage the device.
X. DISPOSING OF THE DEVICE
When disposing of the device. Do not bring it to regular municipal waste containers. Instead, bring it
to electrical and electronic waste recycling and reuse center. A relevant label has been put on the device,
its manual or on the package. The device has been manufactured of recyclable materials. By bringing
old device to recycling collection center, you contribute to environmental protection.
Ask your local environmental care authority for information on location of such facilities.
11
0
P L E N R U D E