Advertisement
InBin-P-100
Parametrisation and commissioning of InBin-P-100 transducers
Preparation of parametrisation / operation
Operation
Parametrisation,
push
If password (PW) protection is active: put PW in, push
Menu
Function
Menu 1 Preset
select application
Menu 2
unit sensor 1
select physical unit
Menu 3 set 1
select switching
point 1
Menu 4 no function – menu skip
Menu 5 hysteresis*
select physical unit
Menu 6 mode*
select switching
charateristic
Menu 7
no function – menu skip
Menu 8
no function – menu skip
Menu 9
no function – menu skip
no function – menu skip
Menu 10
Menu 11
no function – menu skip
Menu 12
time
select time for
starting bypass (AUB) and
switch activation delay
Menü 13
lamp
select backlight
Menu 14
zero point compensation
Menu 15
security
select password
save
Menu 16
select save data
* Useable in professional mode only (see Menu 1 – professional mode)
** Bypass delay
*** Switch activation delay:
With this function the condition „normal operation"can be hold for the selected time.
Setting the switching off delay to „0" will deactive the function.
Schischek GmbH Germany, Mühlsteig 45, Gewerbegebiet Süd 5, 90579 Langenzenn, Tel. +49 9101 9081-0, Fax +49 9101 9081-77, E-Mail info-de@schischek.com
for 3 sec.
Enter
Indication
www.schischek.com
E X P L O S I O N P R O O F
Change operation-/parametrisation mode
To change from operation to parametrisation mode push
„Enter button"
for minimum 3 seconds. Back over the
menu save.
Select
Enter
Next indication
Pa, mBar, InH 2 O
adjust set 1
adjust hysteresis
norm. open (no), norm. closed (nc)
adjust bypass time**
on, off
enter password
no, yes, return, default setting
Next selection
Enter
Next menu
select normal sensor interval
adjust switching off delay***
D.IB-P100-02.01-en
23-Aug-2012
4 / 6
Advertisement
