Operation; Pes-A02-Ia-Defsi - KERN PES-A02 Installation Instructions Manual

4 Operation

1. Connect mains adapter and start the balance by pressing the ON/OFF key
2. Entering limiting values
3. Evaluation of readings via relay contacts
4. Status balance/contact
Status balance
Reading outside condition
Reading outside range
Input of invalid values
Error message
(o-ERR/u-ERR)
During input
Waiting for stability
message as per tares
Stand-by
Sleep mode
Automatic check of
balance at starting
5. Output by external signal
• Contacts and audio signals are started by the weighing result, but may also be
triggered by an external signal
• Whilst the menu is set [2B. R.Q.m. 2] there is an output of the weighing result for
approx. 200 ms after the signal was applied
• For pulsed, external signals the output signal will follow after 100 ms at the
earliest

PES-A02-IA-defsi-0610

Display
No reading display
No reading display
Five symbols appear
on the left
o-ERR/u-ERR
Input appears on display
[M] flashing
Stand by LED glowing
Sleep LED glowing
[88888888] glowing
Contact
inactive
inactive
inactive
• OFF during measure-
ment of limits 1-5
• ON during ERR
inactive
Last display fixated
inactive
Output of evaluation result
inactive
15