Roland Camm-1Pro Series User Manual page 52

Details of the Origin-point Location and Cutting Area
The Location of the Origin Point Immediately After Loading Material (When [ROTATE]
is set to [0deg])
"ROLL" (When using roll material)
3
(0. 0)
"F-EDGE" (When performing cutting from as close as possible to the front edge of
the material)
(0. 0)
"R-EDGE" (When using the front-loading feature)
(0. 0)
"PIECE" (When using flat material)
(0. 0)
* For detailed information about the cutting area, see the following page.
50
Material
Pinch roller
Depends on length
Margin
Material
Pinch roller
Margin 30 mm
30 mm
Material
Pinch roller
30 mm
Material
Pinch roller
30 mm
Margin
The origin point is set at the location where the mate-
rial is loaded, near the left pinch roller.
Set the origin point at a location having a margin of 30
mm (1-3/16 in.) from the front edge of the material.
Set the origin point at a location having a margin of 30
mm (1-3/16 in.) from the trailing edge of the material.
When in this state, the cutting area is zero.
After length in the direction of material feed is de-
tected, movement 30 mm (1-3/16 in.) back from the
front edge of the material is performed, and the origin
point is set near the left pinch roller.
* When the length of the material is 1,600 mm (63
in.) or longer, the material is determined to be roll
material. The origin point is set in the same way as
for "ROLL" above.