dji MAVIC MINI User Manual page 22

Mavic Mini User Manual
The battery cannot be charged if the aircraft is powered on and the aircraft cannot be powered
on during charging.
DO NOT charge an Intelligent Flight Battery immediately after flight as the temperature may be
too high. Wait until it cools down to room temperature before charging again.
The charger stops charging the battery if the battery cell temperature is not within the operating
range of 41° to 104° F (5° to 40° C). The ideal charging temperature is 71.6° to 82.4° F (22° to 28° C).
The Battery Charging Hub (not included) can charge up to three batteries. Visit the official DJI
Online Store to learn more.
DJI does not take any responsibility for damage caused by third-party charger.
Discharging
It is recommended to discharge the Intelligent Flight Batteries to 30% or lower. This can be done
by flying the aircraft outdoors until there is less than 30% charge left.
Battery Level LEDs During Charging
The table below shows battery level during charging.
LED1 LED2
The blinking frequency of the battery level LEDs will be different when using different USB
charger. If the charging speed is fast, the battery level LEDs will blink quickly. If the charging
speed is extremely slow, the battery level LEDs will blink slowly (once every two seconds). It is
recommended to change the Micro USB cable or USB charger.
If there is no battery in the aircraft, LED 3 and 4 will blink three times alternatively.
The four LEDs blink simultaneously to indicate the battery is damaged.
Battery Protection Mechanisms
The battery LED indicator can display battery protection indications triggered by abnormal charging
conditions.
Battery Protection Mechanisms
LED1 LED2 LED3
©
22 2019 DJI All Rights Reserved.
LED3 LED4
LED4 Blinking Pattern
LED2 blinks twice per second
LED2 blinks three times per
second
LED3 blinks twice per second
LED3 blinks three times per
second
LED4 blinks twice per second
Battery Level
0% ＜ battery level ≤ 50%
50% ＜ battery level ≤ 75%
75% ＜ battery level ＜ 100%
Fully charged
Battery Protection Item
Overcurrent detected
Short circuit detected
Overcharge detected
Over-voltage charger detected
Charging temperature is too low