Install The Door Control (Motion Detecting Control Panel) - Chamberlain RJO70 Manual

Installation
(continued)
8
Install the Door Control
Install door control within sight of garage door, out of reach of small
children at a minimum height of 5 feet (1.5 m) above floors, landings,
steps or any other adjacent walking surface, and away from ALL moving
parts of door.
For gang box installations it is not necessary to drill holes or install the
drywall anchors. Use the existing holes in the gang box.
1. Strip 7/16" (11 mm) of insulation from one end of the wire and separate
the wires.
2. Connect wires to the door control. Make sure the polarity is correct.
• Connect the red wire to the RED terminal.
• Connect the white wire to the WHT terminal.
3. Mark the location of the bottom mounting hole and drill a 5/32" (4 mm)
hole.
4. Install the bottom screw, allowing 1/8" (3 mm) to protrude from the wall.
5. Position the bottom hole of the door control over the screw and slide
down into place.
6. Lift the push bar up and mark the top hole.
7. Remove the door control from the wall and drill a 5/32" (4 mm) hole for
the top screw.
8. Position the bottom hole of the door control over the screw and slide
down into place. Attach the top screw.
9. Run the white and red/white wire from the door control to the garage
door opener. Attach the wire to the wall and ceiling with the staples (not
applicable for gang box or pre-wired installations).
10. Strip 7/16" (11 mm) of insulation from the end of the wire near the
garage door opener. Connect wire to the quick-connect terminals on the
garage door opener: white to white and white/red to red.
11. Fasten the warning placard to the wall next to the door control.
NOTE: DO NOT connect the power and operate the garage door opener at
this time. The door will travel to the full open position but will not return
to the close position until the safety reversing sensors are connected and
properly aligned. See page 18.
(to garage
door opener)
7
3
4
Push bar
6
8
5
Screw 6ABx1-1/4" (Standard installation) (2)
7/16" (11 mm)
1
Tabs
2
(to door control)
16
To prevent possible SERIOUS
INJURY or DEATH from electrocution:
• Be sure power is NOT connected
BEFORE installing door control.
• Connect ONLY to 7-28 VOLT low
voltage wires.
To prevent possible SERIOUS
INJURY or DEATH from a closing
garage door:
• Install door control within sight of
garage door, out of reach of small
children at a minimum height of 5
feet (1.5 m) above floors, landings,
steps or any other adjacent walking
surface, and away from ALL
moving parts of door.
• NEVER permit children to
operate or play with door control
push buttons or remote control
transmitters.
• Activate door ONLY when it can be
seen clearly, is properly adjusted,
and there are no obstructions to
door travel.
• ALWAYS keep garage door in sight
until completely closed. NEVER
permit anyone to cross path of
closing garage door.
YOU WILL NEED
Drywall
Anchors (2)
10
Red White
WHT/RED
9
Screw 6-32x1"
(pre-wired) (2)
To insert or
release
wire, push
in tab with
screwdriver
tip
WHT