Advertisement
Step 3
Use the protector tape included in the bolt kit on the Support Tube just below the extension pan to prevent paint from
scratching. Attach the stiffener connecting bracket to 5/16" stud in desired location and the stiffener. Secure the
bracket with flat washer (a) and nyloc nut (b).
Step 4
Detach the Ladder Hook and Ladder Stop on the original pan, and install onto the new extension kit as shown. Attach
ladder hook to ladder pans on 5/16" studs in desired location. Attach ladder stop to coincide with ladder hook by using
3/8"‐16 x 1" Hex bolt(e), 3/8" flat washers(c), 3/8" nyloc nut(d) and placing stop so the tab on the stop goes into the
corresponding hole and slot.
The installation is complete.
Rear of Vehicle
Protector Tape
(a)
(b)
3
Stiffener
Protector Tape
Connecting
Bracket
Front of Vehicle
Advertisement
