Suzuki Reno 2008 Reno Owner's Manual page 169

SERVICE AND APPEARANCE CARE
Center High-Mounted Stop Lamp
To replace a center high-mounted stop
lamp bulb:
1) Open the liftgate.
2) Pry off the trim and remove the two
screws shown in the illustration.
3) Remove the bulb socket from the lamp
housing.
4) Remove the bulb by pulling it straight
out of the bulb socket.
5) Install the appropriate bulb into the
socket. See "Replacement Bulbs" in
this section.
6) Replace the lamp housing and trim in
reverse order.
5-25
Luggage Compartment Lamp
N4U5046A
To replace a luggage compartment lamp
bulb:
1) Use a flat screwdriver to pry the lamp
assembly from the lamp assembly
holder.
2) Replace the bulb. See "Replacement
Bulbs" in this section for the proper
bulb.
3) Reinstall the lamp assembly.
Tail/Stop Lamps and Rear Turn Sig-
nal Lamps
To replace a tail/stop lamp or a rear turn
signal lamp bulb:
1) Open the liftgate.
2) Remove the two screws and the lamp
assembly.
3) Remove the bulb socket from the lamp
housing by turning the bulb socket
counterclockwise.
4) Remove the bulb from the socket by
pressing the bulb and turning it counter-
clockwise.
5) Install the appropriate bulb into the
socket. See "Replacement Bulbs" in
this section.
6) Replace the bulb socket into the lamp
housing.
N4U5044A