Six-Monthly Maintenance; Splash Guard Replacement; Troubleshooting Guide; The Suction Motor Does Not Work - Floorpul ruby 48 blt Use And Maintenance

Table of Contents

Advertisement

6.
Replace the front rubber.
7.
To reassemble the squeegee repeat reverse the operations above-
mentioned.

SIX-MONTHLY MAINTENANCE

SPLASH GUARD REPLACEMENT

1.
Unscrew the knobs in the rear part of the brush base group from
the extremity of the metal strips. The operation has to be carried
out on both splash guards.
2.
Unscrew the nut on the front part of the brush base group and
take off the metal strips.
3.
Replace the splash guard rubbers and follow the assembling
instructions at "SPLASH GUARD ASSEMBLY" paragraph.
With the brush assembled, the splash guard must slightly touch the
floor.

TROUBLESHOOTING GUIDE

The checking of all the other foreseen machine operations is left
to the authorized technical assistance.

THE SUCTION MOTOR DOES NOT WORK

1.
Verify that the switch (3) is on.
2.
Check the charge level of the batteries: pressing the switch of
the brush motor (2) the signal lamp of the battery charge level
(1) comes on. Check that it is in green colour. If the red colour
appears, it is necessary to proceed for the batteries' recharge
(see under "BATTERIES RECHARGING").
3.
Check that the battery connector (1) is correctly plugged in.
If the problem persists, please contact the authorized technical
assistance.

THE BRUSH MOTOR DOES NOT WORK

1.
Verify that the switch (2) is on.
2.
Activate the levers movement.
3.
Check the charge level of the batteries: pressing the switch of
the brush motor (2) the signal lamp of the battery charge level
(1) comes on. Check that it is in green colour. If the red colour
appears, it is necessary to proceed for the batteries' recharge
(see under "BATTERIES RECHARGING").
4.
Check that the battery connector (1) is correctly plugged in.
If the problem persists, please contact the authorized technical
assistance.
Never leave the batteries discharged for a long time.

INSUFFICIENT WATER ON THE BRUSH

1.
Check that the solution valve lever (6) is open.
2.
Check the level of the liquid in the solution tank.
3.
Check that solution filter (1) is clean.
If the problem persists, please contact the authorized technical
assistance.
14

Advertisement

Table of Contents
loading

Table of Contents