Sub-Zero ID-24RO Installation Manual

CONTENTS
2 Panel, drawer
2 Trim, cabinet side
1 Assembly, lock
1 Shim, plastic 3/32"
1 Shim, plastic 1/4"
1 Bracket, center
1 Pocket, lock
2 Washer
2 Nut
16 Screw, #8 x 32 x ½"
ID-24RO STAINLESS STEEL PANEL INSTALLATION
For panels without a lock, proceed to step 14.
1
Remove both drawers.
2
3 Remove the existing side mounting brackets.
4 Install one of the new cabinet side trims using the
existing screws. The mounting stud on the side trim
should align with the bottom of the center mullion.
5 Place the center bracket onto the mounting stud, then
loosely secure with a washer and a nut.
9012313 REV-A 12/2016
ID-24RO Stainless Steel Panel Installation
6 Install the remaining cabinet side trim using the existing
screws, then loosely secure to the center bracket stud
with a washer and a nut.
Install the upper drawer.
7
Place the 3/32 plastic shim above the center bracket
8
and below the upper drawer.
Move the center bracket up or down to achieve proper
9
spacing, then tighten both nuts to secure each side of
the bracket.
Discard the shim.
10
Install the bottom drawer.
11
Page 1 of 2
subzero.com 800.222.7820
*9012313$REVA*