Table of Contents
Advertisement
Step 20.
Step 21.
recorded in the 'cable numbered' column on Page YZ839.
Refer to that page to locate the LlCs in LlB1 or LlB2 boards.
If any error appears (LiC presence missing) make a visual
check of the board in error. check that the LA-to-MUX cable is
properly connected. If necessary, use the MIP for trouble-
shooting.
• For a TRSS/HPTSS, the LA-to-MUX cabling cannot be modified.
Refer to Page YZ 544 for details on connection and port
addresses.
Remote/Alternate Console Link Test
RSF Link Test
a. Install the console wrap tool
(PIN
6398697) in the remotelalternate
console connector at 01 R-AOJ2.
Location: 018-;\0
(~~ I---~J
I
'-
i
nSF
Remote
I
AJterrate Local,
J1
J2
J3
b. On the control panel, select Service Mode
=
1, and press the Vali-
date key; then select Function
=
6, and press the Validate key to
start the test.
Successful diagnostic completion will give panel code 184. For
any other code refer to the MIP.
c. Remove the wrap tool.
a. Install the console wrap tool
(PIN
6398697) in the RSF connector at
01 R-AOJ1.
b. On the control panel, select Service Mode
=
1, and press the Vali-
date key; then select Function
=
7, and press the Validate key to
start the test.
Successful diagnostic completion will give panel code 186. For
any other code refer to the MIP.
c. Remove the wrap tool.
d. At the control panel, select Service Mode
=
1, and press the Vali-
date key; then
se~ect
Function
=
1, and press the Validate key. A
MOSS IML occurs.
Wait for code FOE/FOF. The CA interface status will be displayed
at the console. At this step of the procedure, the local console is
logged OFF and the MOSS should be able to respond to any
incoming RSF call.
• If no RSF modem is available, go to step 29 on page 3-20.
3-14
3745 Models 130, 150, and 170 Installation Guide
Advertisement
Table of Contents
