Honda CBF125NA 2018 Owner's Manual page 95

20171012170126_32K98B000_eng_BOOK Page 95 Thursday, October 12 2017 17:09:26 JST
Drive Chain Adjusting the Drive Chain Slack
u
Turn both adjusting nuts an equal
5.
number of turns until the correct drive
chain slack is obtained. Turn the adjusting
nuts clockwise to tighten the chain. Turn
the adjusting nuts counterclockwise to
provide more slack.
Adjust the slack at a point midway
between the drive sprocket and the
driven sprocket.
Check the drive chain slack.
Check rear axle alignment by making sure
6.
the chain adjuster index marks align with
the rear edge of the adjusting slots.
Both marks should correspond. If the axle
is misaligned, turn the right or left
adjusting nuts until the marks are aligned
and recheck drive chain slack.
92
Tighten the rear axle nut.
7.
Torque: 88 N·m (9.0 kgf·m, 65 lbf·ft)
Tighten the adjusting nuts lightly, then
8.
hold the adjusting nuts and tighten the
lock nuts.
Recheck drive chain slack.
9.
If a torque wrench was not used for
P. 90
installation, see your dealer as soon as
2
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.