The "Athos" CA-1802 and CA-1803BT car alarms
Thank you very much for buying our CA-1802 or CA-1803BT car alarm. Now you will always be able
to find where you left your car.
Controlling the car alarm by RC-8x remote control
By pressing the
If you re-press the
confirmed acoustically. In this mode, the internal wireless detectors are not active, nor is the
low voltage sensor. Also no voltage is supplied to external sensors.
To rearm the car alarm, press the
has been installed.
Buttons
and
can be used for remotely operating a gate, garage door etc. Please ask your installer
for detailed information.
Remote control via a mobile phone
You can operate the car alarm by your mobile phone. The car alarm sends alarm messages to
the phone and calls after an alarm has been triggered. You can send SMS instructions to the
car alarm's phone number using an authorized mobile phone (see the table below).
In addition, the car alarm allows you remote control by
You only have to dial the car alarm's phone number (while the ignition key is turned off). The car
alarm will not answer the incoming call, but when it recognizes your number, it will change status
(to armed or disarmed). Such remote control is free of charge since the call is not answered.
Status changes can be confirmed by SMS messages.
If you do not remember particular SMS instruction(s) you can ask for help by
sending a HELP instruction.
Default
AM
DM
IMO
UNIMO
STATUS
GPS
LOCATOR
HELP
CREDIT
AUX
parameter
UC xx...x
Only basic ASCII can be used in SMS instruction texts.
Ask the installer to edit the SMS commands for you.
1
Only applicable to the CA-1803BT.
2
Only applicable if supported by the GSM provider.
3
A qualified technician is required for setting up this function.
CA-1803BT, CA-1802 User manual – Mode 1
button you will arm the alarm and if central locking is installed it will also lock.
button (within 15 seconds after arming), partial arming occurs,
button. This will also unlock the car if central locking
SMS instruction texts
Your self-defined text
MODE 1
dialing-in from an authorized phone
3
Arm and lock the car
Disarm and unlock the car
STOP (immobilize) the car (after turning the ignition key off)
Unblock (mobilize) the car
The car alarm replies with status information, e.g.
reports: Time: 27.01.04 13:04, Status: Armed, Unblocked, Ignition off"
To obtain the car location via GPS
To obtain the car location from the GSM provider
The car alarm will reply with a brief list of SMS instructions.
To obtain the balance of a prepaid SIM card, if used
To operate appliances
To change the user code (do this during installation).
xxx...x is the new user code, 4 to 8 characters (A –Z &
0 – 9). The factory default user code is USER
- 1 -
Jablotron s.r.o.
Description
1
3
.
„car
.
2,3
3
MHF56900