Table of Contents
Advertisement
INSTALLATION
6. Using the composite fork clamp
one half of the fork clamp in front of the fork tubes
portions sitting around the face of the lower fork tube. Take the other half and
mate it around the back side of the fork tubes between the fork tubes and the
spindle backer plate. Take the Fork Clamp washer plate
the face of the front fork clamp lining up the bolt holes of the washer plate
with the clamp.
Using Qty.–2, M8 x 75mm bolts
the washer plate, both halves of the fork clamp, and through the spindle
backer plate. Apply the supplied M8 locking nuts
specification listed below.
7. Tighten front axle bolt
Refer to manufacturers specifications for proper torque setting.
8. Check to ensure all previous steps are complete then move on to the rear
cowling assembly section.
64
a
(fork clamp halves are identical), place
i
supplied with your kit, insert bolt through
TORQUE
20 Nm (15 Ft. Lbs)
B
.
IMPORTANT
A
with the concave
s
and place it over
o
and torque to
Advertisement
Table of Contents
