Polaris Timbersled ST 93 RIPPER 2019 Owner's Manual page 60

INSTALLATION
• Honda Models
– Remove the two rear gas tank bolts
bike. Lift up on the rear of the gas tank giving yourself enough room to feed
the brake line and master cylinder over top of the rear right sub-frame tubing
of the bike and under the gas tank as indicated in the image below
the brake line forward under the bottom of the gas tank along the main frame
of the bike. Keeping all of the slack out of the brake line fasten the brake line
to the top and the bottom of the strut rod with cable ties as shown
Reinstall the two rear gas tank bolts
bike manufacturers specification. Next, torque the front tank bolt to
manufacturers specifications. See image below for brake line routing
R
reference :
– Near the front of the bike where the brake line is approaching the front neck
tube of the bike, cable tie the brake line to the front gas tank frame mount
and another cable tie to the bikes frame-mounted wire harness on the bike's
neck tube. See photo below for cable tie locations
line can free hang up to the master cylinder mounted on the right handle bar.
58
A
and loosen the front tank bolt on the
A
previously removed and torque to
F
. The remaining brake
R
Feed
F
.