Snmp Configuration - H3C S9500 Series Operation Manual

Operation Manual – SNMP
H3C S9500 Series Routing Switches

1.2 SNMP Configuration

As configurations for SNMPv3 differ substantially from those of SNMPv1 and SNMPv2c,
their SNMP functionalities will be introduced separately below.
Follow these steps to configure SNMPv3:
Enter system view
Enable SNMP Agent
Configure SNMP Agent
system information
Configure an SNMP agent
group
Add a new user to an
SNMP agent group
Configure the maximum
size of an SNMP packet
that can be received or
sent by an SNMP agent
Configure the engine ID
for a local SNMP agent
To do...
system-view
snmp-agent
snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version { all | { v1 | v2c |
v3 }* } }
snmp-agent group v3
group-name
[ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl
acl-number ]
snmp-agent usm-user
v3 user-name
group-name
[ authentication-mode
{ md5 | sha }
auth-password
[ privacy-mode { des56 |
aes128 } priv-password ] ]
[ acl acl-number ]
snmp-agent packet
max-size byte-count
snmp-agent
local-engineid engineid
Use the command...
1-3
Chapter 1 SNMP Configuration
Remarks
—
Optional
Disabled by default
You can enable SNMP
Agent through this
command or any
commands that begin with
"snmp-agent".
Optional
The defaults are as
follows:
Hangzhou H3C
Technologies Co., Ltd. for
contact,
Hangzhou, China for
location, and <NONE> for
the version.
Required
Required
Optional
1,500 bytes by default
Optional
Company ID and device
ID by default