Table of Contents
Advertisement
Over Temperature Protection
The smart fans will start to work when the lights are on full, or the temperature of the light is over 38°C
(100°F) and will stop when it cools to around 34°C (93°F). If the unit gets too hot, at around 60°C
(140°F), the light will shut down and the display will show
Blue LED Trim Operation
To control the blue LED trim, point the remote control at the infrared sensor on the light unit at the
opposite end from the cable entry.
Press
and
Press
to turn it off and
If you press
the trim will automatically dim and brighten to create a pulsing effect.
COLOUR
DEMO
Troubleshooting
The light does not work
1. Check that it is connected to the power. If not, connect it.
2. Check if the light is in slave mode or off (display showing
3. Check if the brightness is set to '0'. Press
4. Check that the light is not supposed to be off according to your set program. Refer to page 7 to adjust
the program.
The light is always on
1. Check if the total photoperiod is over 24 hours in duration. Refer to page 7 to adjust the program.
2. Check the time is set correctly. Press
The screen displays
1. Check if the top of the unit and fans are blocked or covered. If they are, remove dust/debris to ensure
good air flow.
2. Check if the fans are operating. If not then refer to Tropical Marine Centre or your local dealer for
replacement fans.
The remote control does not work
1. Check if the light is in slave mode or off (display showing
2. Check that the remote control is pointing to the correct infrared sensor on the light unit for the
operation you are trying to perform. Refer to page 6.
3. Check the battery. This can easily be replaced with a CR2025 coin cell.
The light is flashing
1. Ensure that the light isn't in storm or demo mode. Press
to change the brightness of the blue LED trim up and down.
to turn it back on again.
Err
Err
In
or
OFF
). If so press
or
or
or
and
or
to set the time.
In
or
OFF
to return to run mode.
RUN
9
to return to run mode.
or
to adjust the brightness level.
). If so press
RUN
to return to run mode.
Hide quick links:
Advertisement
Table of Contents
