Using Your Water Dispenser - Electrolux EQAXF01BXSI User Manual

Using your water dispenser

Locate dispenser
1. Place dispenser upright.
2. Locate dispenser on a hard and level surface in a cool shaded location
near a grounded socket. Do not plug in power cord yet.
3. Position dispenser so the back is at least 20 cm from wall and there are
at least 20 cm of clearance on both sides.
Assemble
1. Snap drip tray and grid assembly into front carapace.
Machine Installation
Installing the floor Bracket kit(Fig.6)
1. Use 13 mm screw to fix the fixing bracket on the
side of base pan.
2. Drill out a screw hole(6 mm) on the floor.
3. Insert a screw anchor (wall plug) into the drilled hole.
4. Move water dispenser, Align fixing bracket hole
with screw hole of the floor.
5. Put the 25mm screw into the screw hole of fixing
bracket.
6. Tighten the screw.
1 1
Install water bottle
1. Open cabinet door.
2. Place fresh bottle outside of cabinet.
3. Remove the entire plastic cap from top
of bottle.
4. Clean outside of new bottle with a cloth.
5. Place probe assembly into bottle.
6. Slide collar with head down until it clicks
in place.
7. Slide bottle into cabinet and close door.
2-3
1
4-5 6
Head
Collar
7
Water dispenser
Bracket
The hole for
tighten screw
Fig. 6
Fig.
7