Programming Spaberry Functions - SpaBerry Owner's Manual

Programming the SpaBerry Functions
Heat Modes (via the Program Button)
Standard Mode: maintains the desired temperature. Note that the last measured spa temperature displayed is cur-
rent only when the pump has been running for at least 1 minute. "STD" will appear on the display momentarily
when you switch into Standard Mode.
Economy Mode: heats the spa to the set temperature only during filter cycles. "ECN" will alternate with the tem-
perature when the temperature is current. "ECN" will alternate with "- - -" when the temperature is not current.
Pressing "Jets" while in economy mode puts the spa in Standard-In-Economy-Mode, ("SE") which operates the
same as Standard Mode, then reverts to economy mode after 1 hour. During this time, pressing and releasing
"Program" will revert the mode to Economy immediately.
Sleep Mode: heats the spa to within 20°F/11°C of the set temperature only during filter cycles. "SLP" will alter-
nate with the temperature when the temperature is current. "SLP" will alternate with "- - -" when the temperature
is not current.
The Program button is used to switch between Standard, Economy, and Sleep modes. Press and release "Program"
to enter Mode Programming, press "Down" to cycle through to desired mode (LED display flashes until con-
firmed), then press "Program" to confirm selection.
Filter Cycles & °F vs. °C (via the Program Button)
The pump will run in low speed during filtration.
The first filter cycle ("day") begins 6 minutes after the spa is powered on. The second filter cycle ("night") begins
12 hours after the first one. Filter duration is programmable for 0.5-6.0 hours ("F0.5"-"F6.0"). The default filter
duration is 2 hours.
The Program button is used to set filtration cycles. Hold down "Program" for at least 3 seconds. When Filter
Duration appears, press "Down" or "Up" to select the filter duration. Press "Program" to select the number of fil-
ter cycles. The display will show "dn" (both "day" and "night" cycles); "d" ("day" cycle only); or "n" ("night"
cycle only). Press "Down" or "Up" to adjust.
The Program button is also used to change between °F and °C. After filtration is set, press "Program" to select
Fahrenheit ("F") or Celsius ("C"). Press "Down" or "Up" to adjust. Press "Program" again to exit the program-
ming mode.
The "Filter" LED indicator lights when either filter cycle is running.
CAUTION
: Long and/or numerous filter cycles could cause overheating of the SpaBerry, especially in
hot climates.
Dynamic L.E.D Light
SpaBerry is equipped with a main LED light that controls the colors by pushing the light button on the keypad.
To Operate Light Functions:

Press Light key once and the first color pattern sequence will be displayed

To activate the next color pattern, press Light key again. Light will turn off, then press Light key within 3
seconds to activate the next color sequence.
The Color Pattern Sequences are:

Fade (Blue-Green)

Solid White

Solid Pink

Solid Purple

Solid Blue

Solid Dark Blue
Owner's Manual

Solid Teal

Solid Green

Slow Fade

Quick Fade

Quick Change

Fast Strobe
18