Sunfire SRS210W-B Installation Instructions Manual page 17

Baffle installation procedure
1. Remove the debris shield from the
front of the in-wall cabinet. You can
do this by cutting the cardboard
with a sharp knife and pulling out
the cardboard pieces and the plas-
tic rivets holding it in place. Do not
cut the two wires inside the cabinet,
and do not remove any sound-
proofing material.
Removing the debris shield
2. With the help of an assistant, hold
the baffle assembly close to the
in-wall cabinet.
. Connect the two wires from the
inside of the cabinet to the two
push-terminals on the crossover
board, following this diagram:
Red Wire
(Positive +)
Black Wire
(Negative –)
Attaching the cabinet wires to the crossover
board fixed to the woofer baffle assembly
(I-BEAM omitted for clarity)
User's Manual
4. Secure the woofer baffle assem-
bly to the in-wall cabinet using 14
Allen-head screws and washers
supplied. Make sure the two wires
do not get pinched.
Installing the woofer baffle assembly
5. Before putting the grille frame and
grille on, test the subwoofer to see
if all the connections are made
correctly. See the user's guide that
comes with your SubRosa ampli-
fier.
The woofer baffle assembly in place
17