SMC Networks Elite16 Manual page 23

W 2 :
The W l jumper block (refer to Table 5
in the "Installing a Boot ROM" sec-
tion) is used with an optional boot
ROM device. The jumper should be
set to NONE/SOF if you are not
using a ROM device. Ttie "Installing a
Boot ROM' section provides detailed
instructions on inserting and configur-
ing an optional boot ROM.
After you have configured the adapter
and (if desired) installed an optional
boot ROM device, you are ready to in-
stall the adapter in your computer
Selection between coaxial and
twisted pair network interface is auto-
matic. When connected to a valid
twisted pair link, the adapter will
switch into twisted pair interface
mode (indicated by "link" LED on).
When no valid twisted pair link is
found (indicated by "link" LED off) the
adapter will switch into coaxial mode.
25