Page 2
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
7360-K038 Processor Upgrade Installation Procedure Warning: Disconnect the AC power cord before disassembling. Caution: Static Electricity Discharge may permanently damage your system. Discharge any static electricity build up in your body by touching your computer's case for a few seconds. Avoid any contact with internal parts and handle cards only by their external edges.
Page 6
7360-K038 Processor Upgrade 2. Raise the terminal. 3. Disconnect all cables from the Motherboard. 4. Remove the terminal from the tower. a. Remove the four screws that secure the terminal to the display bracket. b. Slide the terminal as shown to detach it from the display bracket.
Page 7
7360-K038 Processor Upgrade 5. Lay the terminal face down on a flat surface. Caution: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down. 6. Remove the Rear Cover. a. Loosen the two captive screws that secure the Rear Cover to the chassis.
Page 8
7360-K038 Processor Upgrade 7. Loosen the spring-loaded screws of the CPU Cooler. Note: Use a sequential rotating pattern when loosening the spring-loaded screws. Loosen each screw a little at a time to evenly raise the CPU Cooler from the CPU.
Page 9
7360-K038 Processor Upgrade 8. Remove the CPU Cooler.
Page 10
7360-K038 Processor Upgrade 9. Remove the CPU from the Motherboard. a. Press down on the CPU Socket Latch and open the Socket Cover. b. Note the orientation of the CPU Module (gold triangle location). c. Carefully remove the CPU with the Handi-Vac CPU Removal Tool and place it in an anti–static packing to protect the CPU contacts from damage and...
Page 11
7360-K038 Processor Upgrade 10. Install the new CPU Module. a. Using a purely vertical motion carefully place the new CPU into the CPU Socket. (The gold triangle on the CPU must align with beveled corner on the socket.) Caution: Always use the Handi-Vac CPU Removal Tool when handling the CPU.
Page 12
7360-K038 Processor Upgrade 12. Remove the old thermal grease from the CPU Cooler surface. • Remove as much of the existing grease from the CPU Cooler surface using a nonabrasive, dull object. A paper towel is an effective choice. • Do not use a sharp, metal object such as a razor blade, knife, trowel, or similar as it may scratch the CPU Cooler surface.
Page 13
7360-K038 Processor Upgrade 13. Install the CPU Cooler on the Motherboard. a. Position the CPU Cooler over the CPU.
Page 14
7360-K038 Processor Upgrade b. Tighten the spring-loaded screws. Note: Use a sequential rotating pattern when tightening the spring-loaded screws. Tighten each screw a little at a time to evenly lower the CPU Cooler onto the CPU. 14. Reinstall the Rear Cover on the terminal.
Page 15
7360-K038 Processor Upgrade 15. Reinstall the terminal on the tower. a. Hook the terminal onto the display bracket. b. Slide the terminal as shown to attach it to the display bracket. c. Secure with four screws. 16. Reconnect the cables to the Motherboard.