Dtmf Control - Dataprobe iBootBar iBP-N15 Installation And Operations

iBootBar – Precision Version

DTMF Control

Models with an internal modem <-M suffix> can be controlled from dial up connections using handset dialing tones
(touch tones). Use of DTMF control requires a unique PIN number set for each user. This PIN is set using the
command line interface and must be 4 to 10 digits long. Program a PIN code of 0 to disable a users ability to use
DTMF control.
DTMF Call Sequence:
1. Dial the phone number connected to the iBootBar. Upon connection a prompt tone will be heard.
2. Enter the PIN followed by the # key. Upon successful entry, a ready tone will be heard. If no PIN or
incorrect PIN is received, an error tone and new prompt tone will be issued. After three unsuccessful
attempts, the iBootBar will hang up.
3. At the ready tone, enter an outlet number 1-8. The current status of that outlet will be stated in English: i.e.
"one on" or "six off".
4. The # key is used to change the state of the outlet. The * key is used to reboot (or power cycle) the outlet
for the time configured with the CLI command cycle time. The new status of the outlet is stated. If the * key
is used, the iBootBar will also state 'begin' to indicate the reboot or cycle has begun.
5. A new prompt tone will indicate that new commands can be entered. While a reboot is in progress,
additional outlets can be addressed and commanded.
6. The caller can hang up at any time to disconnect the call. Any reboots in progress will finish their cycle time
as programmed.
NOTE: Not issuing a command for 5 seconds will cause the iBootBar to hang up.
Notes:
1. The only outlets that a caller has access to are determined by the CLI command set user outlet.
2. While prompts and voice responses are being played, the iBootBar will not process DTMF tones. Wait for
the status and prompts to complete before issuing new commands
3. Address an outlet with a number command before entering a control command (# or *) if unsure which outlet
is being addressed, send the outlet number again.
4. Factory Default user admin has default PIN 23646. Change to desired PIN if maintaining this account.
Resetting to factory defaults will restore this user and PIN.
iBootBar_Precision_20160428e.doc
Page 14
Firmware ver 1.41.32