Operation; Preparation - YILMAZ CA 601 Manual

6.5 Never replace the milling cutters before unplugging first.
6.6
parts
6.7 Do not work on the machine by removing the protective parts
The safety data have been defined above. In order to prevent physical damage or damage to the
equipment, please read the safety information carefully and keep the manual always in an easy
accessible place.

7. OPERATION

7.1 Preparation

7.1.1 Degrease and dry the machine table. Especially ensure that the holding grips and handles are clean and dry
7.1.2 Clean all surfaces of the machine from chip and foreign particles. Use eye glasses for protection.
7.1.3 Control whether cutting tools (FIGURE 6 NO: 63) are inserted safely to their places.
7.1.4 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
7.1.5 Cutting tool must process on the part after machine is operated and cycled.
7.2 Operation
..
7.2.1 Switch
7.2.2 Select the necessary operation through the position selection button (FIGURE 3 NO.10).