Indication Of Uart Output; Indication Of Wireless Transmitting - Ebyte E70-433T14S2 User Manual

Cc1310 433mhz smd wireless module

Hide thumbs Also See for E70-433T14S2:

Table of Contents

Chengdu Ebyte Electronic Technology Co,, Ltd

purpose of broadcast is realized.

5.4 Monitor address



For example: Set the address of module A as 0xFFFF or 0x0000, and the channel as 0x04;



When module A is the receiver, it can receive the data sent from all modules under channel 0x04, the purpose of

monitor is realized.

5.5 Reset



When the module is powered, AUX outputs low level immediately, conducts hardware self-check and sets the

operating mode based on user's parameters. During the process, the AUX remains low level. After the process

completed, the AUX outputs high level and starts to work as per the operating mode combined by M1 and M0.

Therefore, users need to wait the AUX rising edge as the start of module's normal work.

5.6 AUX description



AUX Pin can be used as indication for wireless send & receive buffer and self-check.



It can indicate whether there are data that are not sent yet via wireless way, or whether all wireless data has been sent

through UART, or whether the module is still in the process of self-check initialization.

5.6.1 Indication of UART output



To wake up external MCU



Buffer (empty): the internal 1024 bytes data in the buffer are written to the RFIC (Auto sub-packaging).



When AUX=1, the user can input data less than 1024 bytes continuously without overflow. Buffer (not empty): when

AUX=0, the internal 1024 bytes data in the buffer have not been written to the RFIC completely. If the user starts to

Chengdu Ebyte Electronic Technology Co.,Ltd

E70-433T14S2 user manual

Table of Contents