Installation - Miele KM 360 Installation Instructions Manual

Preparing the worktop
 Create the worktop cut-out as shown
in "Building-in dimensions".
Remember to maintain the minimum
safety distances (see "Safety
distances").
 Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture. The
sealant must be temperature-
resistant.
Make sure the sealant does not
come into contact with the top
surface of the worktop.
The sealing strip ensures that the
cooktop will sit securely in the cut-out
without slipping. Any gap between the
frame and worktop will become
smaller over time.
Installing the cooktop
 Feed the mains connection cable
down through the worktop cut-out.
 Place the cooktop centrally in the
cut-out. When doing this make sure
that the seal of the appliance sits
flush with the worktop on all sides.
This is important to ensure an
effective seal all round.
If the seal does not meet the worktop
correctly on the corners, the corner
radii (≤ R4) can be carefully scribed to
suit.
Do not use any additional sealant
(e.g. silicone).
 Connect the cooktop to the mains
electricity supply.
 Connect the cooktop to the gas
supply (see "Gas connection").

Installation

13