Page 1
LOT NUMBER: DATE PURCHASED: Arris 4 Shelf Tower Book Shelf Stock # MS18-D2-1011-08 ADULT ASSEMBLY REQUIRED If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the store where it was purchased. Please call our customer service number and have your instructions and parts list...
Page 2
M A X I M U M R E C O M M E N D E D W E I G H T L O A D S MANUFACTURER: Whalen Furniture Manufacturing CATALOG: Arris 4 Shelf Tower Book Shelf MODEL # MS18-D2-1011-08 MADE IN CHINA MAXIMUM LOAD 50 lb. (22.7 kg) THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE MAXIMUM WEIGHTS INDICATED.
Page 3
Parts and Hardware List Please read completely through the instructions and verify that all listed parts and hardware are present before beginning assembly. A- Side Frame (Qty. 2) B- Top Shelf (Qty. 1) C- Upper Middle Shelf (Qty. 1) D- Middle Shelf (Qty. 1) E- Lower Middle Shelf (Qty.
Page 4
Assembly Instructions 1” Bolt (8 used in this step) ① Flat Washer 1-3/4” Bolt Lock Washer (2 used in this step) (2 used in this step) (2 used in this step) ③ ② ④ NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back and fully tighten all bolts.
Page 5
Assembly Instructions 1” Bolt (8 used in this step) ① Flat Washer Lock Washer 1-3/4” Bolt (2 used in this step) (2 used in this step) (2 used in this step) ③ ④ ② 5. Repeat the same procedure to attach the other Side Frame (A) at the opposite side.
Page 6
Assembly Instructions Tools required (not provided): Phillips screwdriver, stud finder, power drill and 3 mm/0.1 in drill bit. 6. Ask for assistance to lift the unit upright and position it at the desired location against a wall. If necessary, adjust the pre-attached floor levelers at the bottom of the Side Frames (A) to level the unit. 7.
Care and Maintenance Use a soft, clean cloth that will not scratch the surface when dusting. Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area. Using solvents of any kind on your furniture may damage the finish. ...
Page 9
NÚMERO de LOTE: FECHA de COMPRA: Librero torre de 4 repisas Arris Serie # MS18-D2-1011-08 ENSAMBLE REQUERIDO POR ADULTO Si tienen alguna pregunta acerca del ensamble o si alguna parte está faltante, no retorne esté producto a la tienda donde lo compró. Por favor llame a nuestro departamento de ayuda al cliente teniendo su instructivo y lista de partes para proveer el modelo, nombre de parte o el número de fábrica :...
Page 10
M Á X I M O P E S O R E C O M E N D A D O FABRICANTE: Whalen Furniture Manufacturing CATALOGO: Librero torre de 4 repisas Arris MODELO # MS18-D2-1011-08 HECHO EN CHINA CARGA MÁXIMA 50 lb. (22.7 kg) ESTA UNIDAD DEBE UTILIZARSE CON LOS PESOS MÁXIMOS...
Page 11
Lista de partes y material de ferretería Por favor lea completamente las instrucciones y verifique que estén todas las partes antes de iniciar el ensamblado. A- Marco lateral (Cant. 2) B- Repisa superior (Cant. 1) C- Repisa media superior (Cant. 1) D- Repisa media (Cant.
Page 12
Instructivo de ensamble Perno de 1” usados en este paso ① Arandela plana Perno de 1-3/4” Arandela de presión (2 usados en este paso) usados en este paso (2 usados en este paso) ③ ② ④ NOTA: Por favor no apriete completamente todos los pernos, hasta que termine con el ensamble de las partes, después asegúrese de apretar todos los pernos, esto hará...
Page 13
Instructivo de ensamble Perno de 1” usados en este paso ① Arandela plana Perno de 1-3/4” Arandela de presión (2 usados en este paso) usados en este paso (2 usados en este paso) ② ③ ④ 5. Repetir el mismo procedimiento para adjuntar el otro marco lateral (A) al lado opuesto.
Page 14
Instructivo de ensamble (no incluidas): Desarmador estrella, buscador de estudios, taladro Herramientas adicionales requeridas y broca de 3 mm/0.1 pulgadas. 6. Pedir asistencia para posicionar la unidad ensamblada en posición vertical y en el lugar deseado contra la pared. Si fuera necesario, ajuste los niveladores de piso pre-adjuntados en la parte inferior de los marcos laterales (A) para nivelar la unidad.
Mantenimiento y Cuidados Use una toalla suave y limpia para evitar daños y rayones. Uso de cera para pulir muebles no es necesario. Si desea usar cera, pruébela en un área que no sea visible para revisar su funcionamiento. ...