Dispose Of Waste Properly; Crushing Prevention And Cutting Prevention; Batteries - Rayco RG25HD Operator, Service, Maintenance, Parts Manual

• Obey environmental regulations for the disposal of
asbestos.
• Stay away from areas that might have asbestos particles
in the air

Dispose of Waste Properly

Improperly disposing of waste can threaten the environment.
Potentially harmful fluids should be disposed of according
to local regulations.
Always use leak proof containers when you drain fluids. Do
not pour waste onto the ground, down a drain, or into any
source of water.
Crushing Prevention and Cutting
Prevention
Support the equipment properly before you perform any work
or maintenance beneath that equipment. Do not depend on
the hydraulic cylinders to hold up the equipment. Equipment
can fall if a control is moved, or if a hydraulic line breaks.
Do not perform any work until you have read and followed
the proper "Lock-Out / Tag-Out" procedures.
Do not work beneath the cab of the machine unless the cab
is properly supported.
Unless you are instructed otherwise, never attempt
adjustments while the machine is moving or while the engine
is running.
Never jump across the starter solenoid terminals in order to
start the engine. Unexpected machine movement could result.
Whenever there are equipment control linkages, the clearance
in the linkage area will change with the movement of the
equipment or the machine. Stay clear of areas that may have
800.392.2686
RG25DH Operation • Service • Maintenance • Parts Manual
a sudden change in clearance with machine movement or
equipment movement.
Avoid contact with the rotating feed wheel, cutter wheel
and rotor.
Always shut-off the engine and wait for all moving parts,
belts, fans, rotors, drums, cutting wheels (etc.) to come to a
complete stop before opening access covers and/or guards.
Stay clear of all rotating and moving parts. A moving belt,
pulley, sprocket and chain can suddenly pull a limb into them
causing loss or severe injury.
If it is necessary to remove guards in order to perform
maintenance, always install the guards after the maintenance
is performed.
Keep objects away from moving fan blades. The fan blade
will throw or cut objects.
Do not use a kinked wire cable or a frayed wire cable. Wear
gloves when you handle wire cable.
When you strike a retainer pin with force, the retainer pin
can fly out. The loose retainer pin can injure personnel.
Make sure that the area is clear of people when you strike
a retainer pin. To avoid injury to your eyes, wear protective
glasses when you strike a retainer pin.
If equipment is unhitched from the tow vehicle for operation,
always block the wheels and support the tongue weight
with blocking to prevent unintended movement. Do not use
only the jack stand to support the tongue while in operation.

Batteries

Electrolyte is an acid. Electrolyte can cause personal injury.
Do not allow electrolyte to contact the skin or the eyes.
Always wear protective glasses for servicing batteries. Wash
hands after touching the batteries and connectors. Use of
gloves is recommended.
Safety
11