Panasonic FV-08-11VFL5 Installation Instructions Manual page 3

Hide thumbs Also See for FV-08-11VFL5:
Table of Contents

Advertisement

0
0
0
0
0
Bend near
adaptor
Fig. A
GENERAL SAFETY INFORMATION CONTINUED
AWARNING
This model is UL listed for tub and shower enclosures.
USA only: This product has two fluorescent lamps that contain mercury. Disposal may be
regulated in your community due to environmental considerations. For disposal or recycling
information, please contact your local authorities or visit Panasonic website:
http://www.panasonic.com/environmental or call 1-888-769-0149.
Canada only: Not to be installed in a ceiling thermally insulated to a value greater than R40.
Do not disassemble the unit for reconstruction. It may cause fire or electric shock.
A statement to the effect that when the product is to no longer be used, it must not be left
in place but remove, to prevent it from possibly falling.
Ceiling joist must be subjected to static load more than five times the weight of the product.
Do not install with a method which is not approved in the instructions.
Do not use this fan with any solid-state speed control device. Solid state controls may cause
harmonic distortion which can cause motor humming noise.
This product must be properly grounded.
ACAUTION
Ts
Extreme
Prohibited bending
O
Do not install this ventilating fan where interior room temperature may
exceed 104°F(40°C).
O
Make sure that the electric service supply voltage is AC 120V, 60Hz.
Bend
Prohibited repeatedly
O
OO
Follow all local electrical and safety codes, as well as the National
Electrical Code (NEC) and the Occupation Safety and Health Act (OSHA).
Always disconnect the power source before working on or near the fan,
motor, light fixture or junction box.
Prohibited
Protect the supply wiring from sharp edges, oil, grease, hot surfaces,
chemicals or other objects.
O
Do not kink the supply wiring.
O
Provide make up air for proper ventilation.
O
For general ventilating use only. Do not use to exhaust hazardous or
(cooking area)
explosive materials and vapors.
Do not install above or
in Fig.A.
•1—
inside this area
—/
\\\
1
\
Do not install the unit where ducts are configured as shown
/
/
\
///
\D.
+
Q s, / /
O
Not for use in cooking area. (Fig.B)
\
/
Cnnkina
Floor
O
The special-purpose or dedicated parts, such as mounting
fixtures, must be used if such parts are provided.
Duct
narrow
Adaptor
Fig. B
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents