LEAD dynamic PDW Series Operating Manual page 6

ENGLISH
1.3
Mounting as a surface-mounted light
Installation with optionally
FRAME PF (See also installation instructions for
accessories)
Assemble the four profiles and screw them together
using four screws in the holes provided on both end
caps. Attach the frame to the ceiling. You must use
attachment materials that are appropriate for your
ceiling. Loosen an end cap from the frame, connect
to the mains and insert your panel.
Now screw the end cap back on using the four
screws.
1.5
Mounting as suspended light without frame
See also installation instructions for accessories.
1. Fix the installation socket of your ROPE HANGER SET to the ceiling. You must use fixing materials that are appro-
priate for your ceiling for this purpose.
2. Mount the counterparts to your ROPE HANGER SET on the PANEL FRAME in the drilling holes provided using the
screws enclosed.
3. Screw the end pieces of your ROPE HANGER SET to the previously attached counterparts on the panel.
4. Connect to the mains.
LEAD ENERGY AG Am Stadtbad 37 45219 Essen-Kettwig
available PANEL
Subject to errors and amendments
1.4
Mounting as suspended light with frame
You will also need a ROPE HANGER SET in addition
to the frame for this.
Assemble the four profiles and screw them
together using four screws in the holes provided
on both end caps. Fix the installation socket of
your ROPE HANGER SET to the ceiling. You must
use fixing materials that are appropriate for your
ceiling for this purpose. Attach the ends of your
ROPE HANGER SET provided for this purpose to the
PANEL FRAME. Loosen an end cap from the frame
and insert your panel.
Now screw the end cap back on using the four
screws and connect to the mains.
Information / Technical support: www.lead-energy.com