LEAD dynamic PDW Series Operating Manual page 5

ENGLISH
Thank you for choosing a product from LEAD energy
AG. If you would like to get in touch with our service
team, please contact them via our website or by
e-mail.
Intended use
You can install the PDW and PDC panels in grid ceil-
ings or install them as surface mounted ceiling lights
or suspended lights using the accessories that are
available separately.
1
Mounting
Note that the WLAN controller for your luminaire
must be accessible for product configuration. You
can also configure your luminaire prior to instal-
lation. The settings will be maintained even if the
power supply is disconnected. Make a note of the
SSID and password of the WLAN controller.
1.2
Mounting in suspended ceilings (this type of installation is only possible with PDW panels)
Fix the spring clips provided to your panel using the screws. Make a ceiling cut-out; the size of the cut-out can be
selected from the following list: PDW 30: 289 x 289 mm, PDW 62: 609 x 609 mm, PDW 60: 589 x 289 mm, PDW 120
SLIM: 1189 x 139 mm und PDW 120: 1189 x 289 mm
The cut-out must be extremely precise. The edges of the cut-out must be able to bear the weight of the luminaire.
Connect the power supply in the ceiling. Insert the panel into the cut-out in the ceiling by pressing back the spring
clips. Make sure the panel is locked fully into place.
LEAD ENERGY AG Am Stadtbad 37 45219 Essen-Kettwig
Note
Please observe the warnings prior to installation.
1.1
You can install your PDC or PDW in grid ceilings by
replacing a ceiling panel with the respective light
panel. The size of the ceiling panel must match that
Subject to errors and amendments
?
service@lead-energy.com
www.lead-energy.com
Mounting in grid ceilings
Information / Technical support: www.lead-energy.com