Waeco PerfectView RV-FM-10 Installation Manual page 24

_RV-FM-10.book Seite 24 Mittwoch, 11. Januar 2006 11:03 11
Installing the radio link
Check beforehand that there is sufficient room for the drill head to emerge
once the holes have been made.
Transmitter module: Make sure you can lay the connection cable to
the camera.
Receiver module: Make sure you can lay the connection cable to
the monitor.
Note
The receiver module must be set to the same channel as the trans-
mitter. Check this before starting up.
Note
Pictures and sound are sent from the transmitter to the receiver.
To ensure flawless functioning, you need to check whether the
wireless transmission is stable before final assembly.
To do this, proceed as follows:
➤ Attach the modules temporarily to the planned installation location.
➤ Install the rear view video system if you have not already done so.
➤ Close all doors, including vehicle doors, and sit in the driver's seat.
➤ Start up the rear view video system.
If the camera image is transmitted steadily, you can permanently install
the modules.
If there is interference, turn or move the transmitter slightly and test it again.
To perform the installation, proceed as follows:
Note
There are two ways to fasten the two modules:
– Using the adhesive pad supplied
Make sure the adhesive surfaces (surface and bottom of the
module) are clean, dry and free of grease.
– Using self-tapping screws
To do this you need to drill four holes for each module.
➤ Hold the module at the chosen location and mark four different points for
drill holes (fig. 7, page 4).
➤ Drill 4 mm diameter holes at the points you just marked.
24
PerfectView