Martec MPREM Operation And Installation Instructions

IMPORTANT SAFEGUARDS:

Read and save these instructions.
All fixed wiring appliances must be installed by a qualified electrical contractor and follow AS/NZS3000.
The remote controller receiver part must be installed inside the fan canopy and should not be installed in the ceiling.
The supply to the remote control receiver should be connected through a mains switch (i.e existing wall switch).
This unit is to be used for the control of ceiling fan only, and to be connected to 220-240V~50Hz power supply
only , do not exceed rated power input specification.
Do not install within very close proximity of lamps or immerse into water.
For indoors use only.
Do not pull on or cut wires or metal rods shorter.
Do not drop or bump the unit.
Do not modify this unit in anyway.
Do not install in damp locations , Never immerse in water or allow either component to become wet.
Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.
Set the ceiling fan wall speed control rotary switch (if any) to HIGH and light kit (if any) to ON position before
operating remote control function of this product.
Note: Batteries in the transmitter should be replaced at proper intervals to avoid leaks and damages to the
transmitter. Follow state regulations and dispose of used battery properly. Keep batteries out of reach of children.
Caution: Always use Martec Fan Speed Controllers. To reduce the risk of fire or injury, do not use this product
in conjunction with any other brands or variable solid-state speed controllers.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THE RECEIVER.
Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pulling the "Pull Switch" after
installation.
Once the connection has been made, insert the receiver into the drop rod-hanging bracket. The canopy comes up
to cover the receiver and bracket. Wires also can be drawn through topside two openings of the receiver if
more space is required to tighten the canopy.
Reciever Installation DIAGRAM:
PREMIER CEILING FAN REMOTE CONTROLLER
OPERATION AND INSTALLATION INSTRUCTIONS
Model : MPREM
In-home
warranty