Alarm.Com Smart Gateway ADC-SG130 User Manual page 4

Add the Smart Gateway to
an Alarm.com account
1. Use an Ethernet cable to connect the
Smart Gateway to an open Ethernet
(RJ-45) port on the existing router.
2. Connect the Smart Gateway's DC power
adapter and plug it in to a non-switched outlet.
NOTE: For optimal Wi-Fi performance, place the
Smart Gateway on top of a table or in another
location free from physical obstructions.
3. Add the device to the account by either
selecting the account in MobileTech or
by using a web browser and entering the
following URL: www.alarm.com/addcamera.
Type in the Smart Gateway's MAC address
to begin. The MAC address is included
on the label on the back of the device.
4
Wi-Fi Protected Setup (WPS) mode
• WPS mode is the preferred way to add
an Alarm.com Wi-Fi camera to the
Smart Gateway's Wi-Fi network.
• Be sure to add the Smart Gateway to an
Alarm.com account before using WPS mode
to add video cameras to the Wi-Fi network.
• To enter WPS mode, use either the Trigger
WPS feature in MobileTech or press and hold
the WPS button for approximately 1 to 3
seconds. The Wi-Fi LED will slowly flash to
indicate that the device is in WPS mode.
5