Dell EqualLogic PS-M4110 Installation Manual page 25

Dell EqualLogic PS-M4110 Installation Guide
After you have installed the PS-M4110 into the M1000e chassis, you can verify proper installation by turning
power ON to the M1000e chassis.
•
If the PS-M4110 is properly installed, the Blade System Status LED on its front panel will light up shortly
after the M1000e is powered on. See
•
If the M1000e is connected to power and turned ON when the PS-M4110 is inserted, the PS-M4110 will
power up as soon as it is fully seated in the M1000e, but the array's Blade System Status front panel LED
may not light up immediately.
If installing the array into a bottom slot in the M1000e chassis
Figure 9: Seating the Array in the Slot
Figure 10 and Table 3 to identify the correct LED.
19