Dell EqualLogic PS-M4110 Installation Guide
Pre-Installation Notes
Before installing the PS-M4110 in an M1000e chassis, note the following:
•
You should wear an electrostatic strap to prevent electrostatic damage. See
•
When shipped by itself, the PS-M4110 includes a retaining clip on the front to prevent the array drawer from
sliding out of the array. It also includes protective plastic covers on the back to protect the rear connectors
from damage. You must remove the retaining clip and protective covers before installing the array in the
M1000e chassis. Optionally, you can also remove the protective caps covering the serial ports on the front.
Save the clip and protective covers for future use.
14
Figure 5: PowerEdge M1000e Chassis
Chapter 3 Installing an Array
Protecting Hardware on page
3.