Robot Coupe MicroMix Manual page 7

removing the tube from the motor unit
- Check that the appliance is not plugged in.
- The tube in the opposite direction to when you
mounted it, until it is completely unscrewed.
removing the blade and the emulsifying tool
- For safety's sake, protect your hand with the blade
locking tool or with a safety glove (or thick cloth)
when detaching one of the tools.
- Using the dismantling tool, unscrew the drive shaft.
- As soon as you have unscrewed the drive shaft, the
blade or emulsifying tool will come free and can
then be cleaned.
L
ocking tooL
B
Lade
F
oot
d
ismantLing tooL
attaching the blade or the emulsifying tool
- To attach either the blender blade or the emulsifying
tool safely, insert it in the bell, then hold it in place
using the locking tool.
- Use this locking tool to screw the tool to the drive
shaft (tightly but not too tightly).
L
ocking tooL
e
muLsiFying tooL
F
oot
d
ismantLing tooL
Easily detachable blender blade and emulsifying
tool for in-depth cleaning, flawless hygiene and
easy aftercare.
The equipment must be clean at all stages of
production.
It is vital to clean the power mixer thoroughly
between each job using a detergent or disinfectant.
• N.B. NEVEr usE PurE BLEaCH
- Dilute the detergent/disinfectant following the
manufacturer's instructions on the labe.
- Scrub well if necessary.
- Leave the disinfectant/detergent to take effect if
necessary.
- Rinse thoroughly.
- Dry properly using a clean cloth.
W a r N I N G
as a precaution, always unplug your appliance
before cleaning it (risk of elec trocution).
after blending hot ingredients, always cool the foot
down under cold running water before detaching it.
Always clean the foot and tools immediately after
use, as food remnants are harder to remove once
they have dried.
• mOTOr uNIT
Never put the motor unit and its handle in water,
HyGIENE clean them with a damp cloth or a sponge.
• FOOT aND BELL
It is possible to proceed in two ways:
• simple cleaning procedure
- Immerse the foot in a container of (preferably hot)
water and switch it on for a few seconds to dislodge
any remaining foodstuffs from the tool and bell.
CLEaNING
15