Siemens RUGGEDCOM MX5000RE Installation Manual page 32

Chapter 2
Installing the Device
2. Align the fan tray with the pins on the bottom of the internal mounting brackets inside the RUGGEDCOM
MX5000RE.
3. Slide the fan tray onto the locating pins until the fan tray mount brackets touch the RUGGEDCOM MX5000RE
inner mount brackets.
4. Secure the fan tray using six (6) screws. Use Loctite® 242 on all screws.
5. Take the free ends of the fan control cables and straighten the cables side by side.
6. Take the right side fan control cable and thread it through the three (3) loops on the left side of the fan tray.
7. Connect the fan control cable to the left side DB25 connector.
8. Repeat Step 6 and
9. Apply Loctite® 222 on the DB25 plug screws. Tighten the DB25 connector screws moderately.
Figure 17: Fan Tray Cable Clips
1. Cable Clip
10. Secure the cables using two (2) cable ties through the slots on the outermost cable clips on the fan tray. Make
sure the cables are held snug and are unable to slide freely.
11. After tightening the cable ties, trim and remove any excess length.
22
Step 7 using the left side fan control cable.
1
RUGGEDCOM MX5000RE
Installation Guide
Installing the Fan Tray