Advertisement
SUNRISE MEDICAL
Switched vs Proportional (Continued) -
v. Next select the port you are trying to configure, which is also the the 9 pin port on the Omni that the Cool Cube is
plugged into.
vi. Specialty Input Device (SID) selection - select one of the following.
Proportional
Allows for proportional
driving and a dedicated
reverse switch
3 Direction Driving - Mode and Forward/Reverse Toggle Set Up -
Setup 1 - Short forward to toggle forward and reverse; user switch for mode.
a.
Ensure powerchair port is set for 3 direction driving.
NOTE: For 2 switch or 3 switch driving, make sure that F/R Auto Toggle is set to "ON", and that F/R Auto Toggle Time is set. For
proportional driving, F/R Auto Toggle Time should be set for 2 seconds or more. This will cause a 2 second delay between
pushing the buttons and the chair moving, but is recommended to allow the user to tap the buttons in order to change the
direction of driving. In 2 switch driving there is also a small delay in pushing of either button or turning. This is in order to allow
for tapping the buttons to switch driving direction. Also in 2 switch driving, make sure that the turning speed is not too high
for the user to easily operate the chair. To access this setting, as also noted below, from the first on board programming
screen, select Omni > Port 1 or 2 > Controls.
F/R Toggle
Set to on
Omni > Port# > Controls
3 Directional Proportional
Allows for proportional driving
and a quick tap forward to
toggle forward and reverse
Auto Toggle Time
Set the time the user needs to
quick tap to toggle forward/
reverse
Omni > Port# > Controls
Switched
Allows for switched driving
and a dedicated reverse
switch
Timeout to Menu
Set to 0
Omni > Port# > Controls
3
COOL CUBE SYSTEMS
3 Direction Switched
Allows for switched driving
and a quick tap forward to
toggle forward and reverse
Double Click Time
Set to 0
Omni > Port# > Switches
246993 Rev. B
Advertisement
