AB Quality ArmorPoint A Series Installation Instructions Manual page 5

Install the Digital
Input Module
To install the digital input module:
1. Using a bladed screwdriver, rotate the keyswitch on the
mounting base clockwise until the number 1 aligns with the
notch in the base.
2. Position the module vertically above the mounting base. The
module will bridge two bases.
3. Push the module down until it engages the latching mechanism.
You will hear a clicking sound when the module is properly
engaged.
The locking mechanism will lock the module to the base.
Remove the Module From the Mounting Base
To remove the module from the mounting base:
1. Put a flat blade screwdriver into the slot of the orange latching
mechanism.
2. Push the screwdriver toward the module to disengage the latch.
The module will lift up off the base.
3. Pull the module off of the base.
ArmorPoint 24V dc Input Modules, Series A
Module will bridge two bases.
43772
Publication 1738-IN002B-EN-E - November 2004
5